Hartridge ADC298 Manual De Funcionamiento Y Servicio página 6

Operating and Servicing Manual
SAFETY INTERLOCK.
Always start the system running at a low pressure and visually check for any leaks
before setting higher pressures. This particularly applies having just mounted a
system, or having just replaced a component.
The pump, injectors, high pressure control valve, delivery lines to the metering unit
and lubricated service drive unit will become hot after running. Wear protective
gloves if handling immediately after use.
Personnel working on this equipment must wear eye protection at all times. Eye
protection must be worn by all personnel near this equipment when it is in use.
Remove any tools, cleaning rags or other debris from the test stand before starting
up. Make sure the inching bar is not fitted to the test stand before starting up.
Use calibration fluid and lube oil of the correct specification only. Obtain the
manufacturers Health & Safety Data Sheets and follow the advice given therein.
Prolonged and repeated contact with oil products, ingestion or excessive and
prolonged inhalation of oil mists can be detrimental to health. Use an appropriate
barrier cream.
Severe injury can be caused by slipping on spilt oils or fluids. All spillages of fluids
in the test area must be dealt with immediately. These can be mopped up and
mineral absorbent material spread over the affected area.
Safety footwear must be worn in the test area at all times. Injury to the feet may be
sustained in the event that equipment under test (during loading or unloading) or
test stand covers are dropped.
Make sure there is adequate ventilation. Oil vapour may be released from hot
fixtures or high pressure leaks. The specific directions in Health & Safety Data
Sheets must be adhered to.
6
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
HARTRIDGE LIMITED
MaualRefNo HL033., IssueNo. 1