Össur i-LIMB WRIST Instrucciones De Uso página 13

Recommended separation distance between portable and mobile RF communications equipment and the Össur
Myoelectric Prosthetic Devices
Össur Myoelectric Prosthetic Devices are intended for use in an electromagnetic environment in which radiated
RF disturbances are controlled. The customers or the user of Össur Myoelectric Prosthetic Devices can help
prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters) and the Össur Myoelectric Prosthetic Devices as recommended
below, according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter in Watt
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in
meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
Note 1: At 80MHz and 800MHz, the separation distance for the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects, and people.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le onctionnement.
Separation distance according to frequency of transmitter in
meters
150 kHz to 80 MHz 80 MHz to 800 MHz
d = 1.2 √P d = 1.2 √P
0.12 0.12
0.38 0.38
1.2 1.2
3.8 3.8
12 12
800 MHz to 2.5GHz
d = 2.3 √P
0.23
0.73
2.3
7.3
23
13