Cleaning, Transportation And Storage; Transportation And Storage; Troubleshooting - PULOX PO-250 Manual De Instrucciones

anemic anoxia and toxic anoxia, some patients with serious anemia
may also report good SpO2 measurement.

7. Cleaning, Transportation and Storage

7.1 Cleaning and Disinfecting
When using alcohol wipes to disinfect the device, please air dry or
clean it with clean soft cloth.
7.2 Maintain
A. Please clean and disinfect the device before using according to the
User Manual (7.1).
B. Please change the battery when the screen shows
C. Take out the battery if leave the equipment unused for long time.

7.3 Transportation and Storage

A. The packed device can be transported by ordinary conveyance or
according to transport contract. The device can not be transported
mixed with toxic, harmful, corrosive material.
B. The packed device should be stored in room with no corrosive
gases and good ventilation. Temperature: -40 °C ~ 60 °C; Humidity:
≤ 95%

8. Troubleshooting

Trouble
The SpO2 and Pulse
Rate can not be
displayed normally
The SpO2 and Pulse
Rate are not
displayed stably
The device can not be
turned on
Possible Reason
1. The finger is not
properly positioned
2. The patient's SpO2
is too low to be
detected.
1. The finger is not
placed inside deep
enough.
2. The finger is
shaking or the patient
is moving.
1. The batteries are
drained or almost
drained.
2. The batteries are
not inserted properly.
3. Malfunction of the
.
Solution
1. Place the finger
properly and try
again.
2. Try again; Go to a
hospital for a
diagnosis if you are
sure the device works
properly.
1. Place the finger
properly and try
again.
2. Calm thw patient
down
1. Change batteries
2. Reinstall batteries.
3. Please contact the
local service center.
EN