Final Assembly; Instruction To The User - Luminance Brands Kathy Ireland Home CARRERA GRANDE ECO CF788AP01 El Manual Del Propietario

6.1
Screw the Two Threaded Studs (supplied) into the
Tapped Holes in the Hanger Bracket (Figure 23) .
6.2
Lift the Ceiling Cover up to the Threaded Studs and
turn until Studs protrude through the Holes in the
Ceiling Cover (Figure 24) .
Secure the Ceiling Cover in place by sliding
Lockwashers over the Threaded Studs and installing
the Two Knurled Knobs (supplied) (Figure 24) .
Tighten the Knurled Knobs securely until the Ceiling
Cover fits snugly against the Ceiling and the Hole in the
Ceiling Cover is clear of the Downrod .
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC
Rules . These limits are designed to provide reasonable protection against harmful interference in a residential installation .
This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications . However, there is no guarantee that interference will not
occur in a particular installation . If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna .
• Increase the separation between the equipment and receiver .
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help .
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules . In order to
maintain compliance with FCC regulations, shielded cables must be used with this equipment . Operation with non-approved
equipment or unshielded cables is likely to result in interference to radio and TV reception . The user is cautioned that changes
and modifications made to the equipment without the approval of manufacturer could void the user's authority to operate this
equipment .
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations .

6. Final Assembly

Figure 23
NOTE: SUPPLY WIRES AND FAN WIRES OMITTED FOR CLARITY.
THREADED
STUDS (2)
Figure 24
Your Fan is now wired to be turned ON and OFF from
the Fan Switch .
15
THREADED
STUDS (2)
Please contact 1-800-777-4440 for further assistance
CEILING
COVER
LOCKWASHERS (2)
KNURLED
KNOBS (2)
luminancebrands.com
ETL Model No.: CF788