Troubleshooting - Luminance Brands Kathy Ireland Home CARRERA GRANDE ECO CF788AP01 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
TROUBLESHOOTING YOUR FAN.
TROUBLE
1. Fan will not start.
1 . Fuse or circuit breaker blown .
2 . Loose power line connections to the fan,
3 . Fan Wall Control is OFF .
2. Fan sounds noisy.
1 . Blades not attached to fan .
2 . Loose screws in motor housing .
3 . Screws securing fan blade flanges to
4 . Wire connectors inside switch housing
5 . Screws holding blades to flanges
3. Fan wobbles
1 . Set screw in motor coupler is loose .
excessively.
2 . Set screw in hanger ball/downrod
3 . Screws securing fan blade flanges to
4 . Fan blade flanges not seated properly .
5 . Hanger bracket and/or ceiling outlet
6 . Fan blades out of balance .

15. Troubleshooting

!
PROBABLE CAUSE
or loose switch wire connections in the
switch housing .
motor hub are loose .
rattling .
are loose .
assembly is loose .
motor are loose .
box is not securely fastened .
WARNING
SUGGESTED REMEDY
1 . Check main and branch circuit fuses or circuit
breakers .
2 . Check line wire connections to fan and switch
wire connections in the switch housing .
Make sure main power is turned OFF.
3 . Turn ON Fan Wall Control .
1 . Attach blades to fan before operating .
2 . Check to make sure all screws in motor housing
are snug (not over-tight) .
3 . Check to make sure the screws which attach
the fan flanges to the motor hub are tight .
4 . Check to make sure wire connectors in switch
housing are not rattling against each other or
against the interior wall of the switch housing .
Make sure main power is turned OFF.
5 . Tighten screws securely .
1 . Tighten both set screws securely in the motor
coupler .
2 . Tighten the set screw in the hanger ball/
downrod assembly .
3 . Check to be sure screws which attach the fan
blade flanges to the motor are tight .
4 . Check to be sure the fan blade flanges seat
firmly and uniformly to the surface of the motor .
If flanges are seated incorrectly, loosen the
flange screws and retighten according to the
procedure in the section on "Ceiling Fan
Assembly" .
5 . Tighten the hanger bracket screws to the outlet
box, and/or secure outlet box .
6 . Interchanging an adjacent (side-by-side) blade
pair can redistribute the weight and result in
smoother operation .
26
WARNING
!
WARNING
!
ETL Model No.: CF788

Publicidad

Tabla de contenido
loading

Tabla de contenido