Installing The Wall Control - Luminance Brands Kathy Ireland Home KEANE CF320BQ00 El Manual Del Propietario

WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
7.1
This Control is designed to operate Only ONE Ceiling
Fan .
NOTE: Electric connections should be in
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to the circuit at the fuse box or circuit breaker
panel.
7.2
NOTE: Make all wiring connections using
wire connectors (supplied). Make sure that all
connections are tight, including ground, and that
no bare wire is visible at the wire connectors,
except for the ground wire.
NOTE: Set the Fan Control to the OFF position.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
Connect the Fan Control Black Wire labeled
"TO POWER SUPPLY" to the "HOT" 120V AC Supply
Source Wire . Securely connect Wires with Wire
Connector, supplied (Figure 25) .
Connect the Fan Control Black Wire labeled
"TO FAN" to the "LOAD" Black Wire in Wall Box .
Securely connect Wires with Wire Connector, supplied
(Figure 25) .
Connect the Fan Control Green Ground Wire to the
Supply Ground Conductor (this may be a bare wire or
wire with Green Colored insulation) . Securely connect
Wires with Wire Connector, supplied (Figure 25) .

7. Installing the Wall Control

Remove the Faceplate and Screws from the Existing
Wall Switch . Pull Switch out from Wall Box .
Determine the "HOT" Wire and the "LOAD" Wire and
disconnect these Wires from the Control (Figure 24) .
NOTE: Do not attempt to disconnect any Wires not
already connected to Existing Switch.
EXISTING WALL SWITCH
SCREWS
SCREWS
Figure 24
TO NEUTRAL
4-SPEED SLIDE
CEILING FAN
CONTROL
OFF
L
POSITION
M 1
M 2
H
O FF
Figure 25
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
15
WALL BOX
FACEPLATE
TO FAN MOTOR LOAD
1.25 AMP MAXIMUM
BLACK WIRES
BLACK WIRES
TO 120VAC
SOURCE HOT
GREEN GROUND WIRES
WARNING
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF320