Preventive Review - Olsen DENTAL LINE Manual Del Usuario

The scaler vibrates little or
10
nothing
11 The scaler is overheating
The scaler has little or no
12
water
The turbine's optical fiber
13
light doesn't work
The electrical micromotor
14 doesn't work or it's
malfunctioning
If you are in doubt or find a problem with the equipment that is not mentioned in this chapter, stop using
the equipment immediately and contact your authorized service center or contact us by e-mail
export3@olsen.odo.br
In order to extend the life of his equipment, Olsen has prepared a list of the main elements of the equipment
that should be reviewed for preventive maintenance.
Olsen recommends performing periodic preventive checks on the equipment, where the technician can, in
addition to the review, assess the state of conservation of the equipment, decreasing the chances of failure.
Preventative checks should be performed with an authorized Olsen technician.
Check base commands and movements.
Check and lubrication motors and joints.
Check out the progressive pedal's valve.
Check out the automatic vapor drain.
Check of the flex arm and working table joints and the pneumatic brake.
Check out the cart unit castors.
Check of the pneumatic couplings pressure and rings.
Check the valves, blades, and handpieces holders.
Check out the scaler tips wear and tear.
Check the Blue Touch panel controls.
Disassembly and lubrication of the 3-way syringe's buttons.
Check out the arm and assistant module movements.
Check the ejection intensity of the Venturi saliva ejector (from 250 to 300 mm/Hg).
Lubrication of the solid's collector rings.
Cleaning and lubrication of the spittoon bowl ring.
2º-Block of 10 consecutive activations
3º-Possible overheating.
1º-There's a problem with the power supply
2º-The tip is not properly attached to the transducer
3º-The tip is worn, or the scaler has a defect
1º-The vibration control is not adjusted according to
tip specification
2º-The tip is not properly attached to the transducer
3º-The tip is worn, or the scaler has a defect
1º-The water tank is empty
2º-The scaler water valve is closed
3º-The tip has a hydro-pneumatic system
1º-The equipment is not performing the movement
2º-The optical fiber's light is switched Off
3º-The handpiece is not properly attached
4º-There's a pneumatic or electronic problem
1º-The equipment is not performing the movement
2º-Pneumatic handpieces are not working properly
3º-The rotation's direction switch is on Off position
4º-The speed control is adjusted to minimum speed
5º-There's a pneumatic or electronic problem
or by calling +55 48 2106 6000.

12 - Preventive Review

DENTAL CHAIR/PROGRESSIVE PEDAL
DELIVERY UNIT/WORKING TABLE
ASSISTANT MODULE/WATER UNIT
2º-Wait at least for 20 seconds to activate the curing
light again
3º-Contact Olsen certified assistance.
1º - Check troubleshooting item 1
2º - Remove and attach the tip again using the
proper wrench
3º - Contact Olsen certified assistance
1º-Adjust the scaler power control according to the
tip specification
2º-Remove and attach the tip again using the proper
wrench
3º-Contact Olsen certified assistance
1º-Fill the water tank
2º-Open scaler water valve
3º-Contact Olsen certified assistance
1º-Check troubleshooting item 1
2º-Turn On the optical fiber's light switch
3º-Reattach the handpiece until the joint gasket is
tighter
4º-Contact Olsen certified assistance
1º-Connect the equipment to the mains electricity
2º-Check troubleshooting item 5
3º-Set the rotation's direction switch to FWD or REV
position
4º-Increase the micromotor's rotation speed
5º-Contact Olsen certified assistance
39