Hanging The Fan - Kichler Monarch II Select Manual De Instrucciones

5. HANGING THE FAN

REMEMBER to turn off the power before you
begin.
To properly install your ceiling fan, follow the
steps below.
Step 1. Remove the decorative canopy
bottom cover from the canopy by turning the
cover counter clockwise. (Fig. 5)
Step 2. Remove the ceiling mounting bracket
from the canopy by removing (and save) one
of the two screws. Loosen the remaining
screw by a half turn. (Fig. 5)
Step 3. Pass the 120 volt supply wires from
the ceiling outlet box through the center of the
ceiling mounting bracket. (Fig.6)
Step 4. Attach the ceiling mounting bracket to
the outlet box using the screws and washers
included with the outlet box. (Fig. 6)
Step 5. Remove the hanger ball from the
downrod assembly by loosening the set
screw, removing the cross pin and sliding the
ball off the rod. (Fig.7)
Step 6. Loosen the two set screws and
remove the hitch pin and retaining clip from
the coupling on top of the motor assembly.
(Fig. 8)
Step 7. Carefully feed the electrical lead wires
from the fan up through the downrod. Thread
the downrod into the coupling until the Hitch
pin holes are aligned.
Next, replace the hitch pin and retaining clip.
Tighten both set screws. (Fig. 8)
Monarch
TM
Fig. 5
UL Listed
outlet box
Ceiling
mounting
bracket
Hook
120V Wires
Fig. 6
Hanger
ball
Fig. 7
Supply wires
Downrod
Set screws
Hitch pin
Fig. 8
II Select
4
Ceiling mounting
bracket
Canopy
Canopy
cover
Washers
Mounting screws
(supplied with
electrical box)
Cross pin
Set screw
Downrod
Coupling
Retaining clip
Set screws