Installing The Transmitter - Kichler Monarch II Select Manual De Instrucciones

16. INSTALLING THE COOLTOUCH
CONTROL SYSTEM WALL PLATE
NOTE: All wiring must be in accordance with the
National Electrical Code and local electrical codes.
Electrical installation should be performed by a
qualified licensed electrician.
Select a location to install your CoolTouch™
Control System Transmitter. You can replace an
existing wall switch or, install the transmitter on
ANY flat surface.
Option 1: Install the control system using an
existing wall switch outlet box.
NOTE: Switch installation must comply with all
local and national electric code.
Make sure the electrical power is TURNED OFF at
the main panel before continuing.
Step 1. Remove the existing wall plate and the old
switch from the wall outlet box. Wire nut the
BLACK leads (hot) together and push back inside
the outlet box. (Fig. 26)
Step 2. Install the metal plate and CoolTouch ™
wall plate to the existing wall outlet box with 4
screws provided. Then place the two plastic
plugs into the wall plate. (Fig. 27)
Option 2: Install the control system on ANY flat
surface.
Select the desired location and use the CootTouch
™ wall plate to mark the location for the mounting
holes. Use the dry wall anchors and screws
provided and finish the installation.

17. INSTALLING THE TRANSMITTER

1. Insert the transmitter into the wall plate by
inserting the bottom of the transmitter first and then
press the top of the transmitter into the pocket. The
transmitter will fully function from this location or
you can remove the transmitter and use as a
"Hand Held" device. (Fig. 28)
2. To remove the transmitter from the wall plate,
push the release button and the transmitter will fall
into your hand.
Monarch
™
Outlet box
Outlet box
Release
button
II Select
TM
Switch
Fig. 26
Metal plate
CoolTouch ™ wall plate
Screws
Screws
Fig. 27
Fig. 28
14
Wall plate
Plastic plugs