Installing The Batteries - Kichler Monarch II Select Manual De Instrucciones

13. INSTALLING THE BATTERIES

Remove the battery compartment cover on the
back of the CoolTouch™ Transmitter and insert
both batteries provided. Make sure the + sign is
facing up.
Take care during this procedure NOT TO move the
frequency dip switches inside this compartment.
The settings MUST remain the same as the
settings on the receiver for proper communication
with the control system.
It's a good idea to remove these batteries if your
fan is not used for extend periods of time,
(months).
NOTE: Make sure Dip Switch #5 is set to the X
position. This disables the dimming function. You
light fixture utilizes CFL lamps that can NOT be
dimmed.
14. OPERATING INSTRUCTIONS
Restore power to ceiling fan and test for
proper operation.
A. , , and
These three buttons are used to set the
fan speed as follows:
= High speed
= Medium speed
= Low speed
B. button:
This button turns the fan off.
C. The " " button: turns the light ON or
OFF and also controls the brightness
setting.
Press and hold either button to set the
desired brightness level. The next time
you turn the light on, the system will
remember this setting.
Press and release either button to turn
the light ON or OFF.
This control system is NOT designed to "Reverse"
the rotation of the blades. to set the fan blades in
reverse, locate the reverse slide switch located on
the side of the Switch Housing. See inset image
at right.
buttons:
Monarch II Select
TM
Fig. 21
Fig. 22
Slide switch
Fig. 23
12
ON
ON D
X
1 2 3 4
Code Switch