Installation Of Safety Support; Electrical Connections - Kichler Monarch II Select Manual De Instrucciones

6. INSTALLATION OF SAFETY SUPPORT

(required for Canadian installation ONLY)
A safety support cable is provided to help
prevent the ceiling fan from falling.
Step 1. Attach the provided wood screw and
washers to the ceiling joist next to the
mounting bracket but do not tighten. (Fig. 11)
Step 2. Adjust the length of the safety cable
to reach the screw and washers by pulling the
extra cable through the cable clamp until the
overall length is correct, put the end of the
cable back through the cable clamp, forming
a loop at the end of the cable. Tighten the
cable clamp securely. Now, put the loop in the
end of the safety cable over the wood screw
and under the washer. Tighten the wood
screw securely.
NOTE: Although the safety support cable is
required for Canadian installations only. It's a
good idea to make the attachment with any
installation.

7. ELECTRICAL CONNECTIONS

WARNING: To avoid possible electrical shock,
be sure you have turned off the power at the
main circuit panel.
NOTE: In the Transmitter, Set Dip Switch #5 on
the D position. This enables the dimming function
because your ceiling utilizes Incandescent lamps
that are dimmable. (See Fig.12)
If this switch is set to the X position it will disable
the dimming function of your fixture.
NOTE: The CoolTouch™ Control System is
equipped with 16 possible frequency
combinations to prevent interference from or with
other remote control units. The frequency
switches on your receiver and transmitter have
been preset at the factory. Please recheck to
make sure the switches on transmitter and
receiver are set to the same position, any
combination of settings will operate the fan as
long as the transmitter and receiver are set to
the same position. (Fig. 12)
Step 1. Insert the receiver into the ceiling
mounting bracket with the flat side of the receiver
facing the ceiling. (Fig. 13) For best
performance, make sure the Black Antenna, on
the end of the receiver, remains extended and
not tangled with any of the electrical wires.
Step 2. Motor to Receiver Electrical
Connections: (Fig. 14) Connect the black wire
from the fan to the black wire marked "TO
MOTOR L" on the receiver.
Monarch
TM
Ceiling mounting
bracket
Fig. 11
ON
ON D
Dip switch
1 2 3 4 X
Fig. 12
Receiver
Fig. 13
II Select
6
Attach
safety cable
to ceiling joist
with screw and
washer
Ceiling Mounting
Bracket