Hanging The Fan - Kichler Lydra 52 Manual De Instrucciones

HANGING THE FAN

Outlet Box
REMEMBER to turn off the power before you begin installation. This is
Ceiling Mounting Bracket
necessary for your safety and also the proper programming of the control
system.
Flat Washer
Screw
To properly install your ceiling fan, follow the steps below.
Step 1. Before attaching fan to outlet box (not included), ensure the outlet box is
securely fastened to at least two points to a structural ceiling member (a loose
Fig. 5
box will cause the fan to wobble). Pass the 120 volt supply wires from the ceiling
Hanger Ball
outlet box through the center of the ceiling mounting bracket. Install mounting
bracket to outlet box in ceiling using the screws and washers included with the
Cross Pin Set Screw
outlet box. (Fig. 5)
Step 2. Remove the hairpin and clevis pin from the downrod assembly, retain for
later use. Remove the hanger ball from the downrod assembly by loosening set
screw, removing the cross pin, and sliding ball of the rod. (Fig. 6)
Downrod
NOTE: Make sure to keep loosened hardware separate to avoid confusion
Hairpin
during installation.
Clevis Pin
Fig. 6
Step 3. Loosen the two set screws on the motor coupling. (Fig. 7)
Set Screw
Motor Body
Fig. 7
52" Lydra LED | 7