Installing The Light Fixture - Kichler Monarch II Select Manual De Instrucciones

11. INSTALLING THE LIGHT FIXTURE

Step 1. Remove the plastic plug from the
center of the switch housing. Attach the light
fixture to the switch housing by feeding the
light fixture wires (black & white) through the
hole in the center of the switch housing, then
screw the light fixture stem into the center
hole. On the inside of the switch housing,
place a lock washer and a nut on the light
fixture stem and tighten. (Fig. 18)
Step 2. Locate the white and blue wires inside
the switch housing labeled FOR LIGHT.
Attach the wires from the light fixture to the
wires inside the switch housing by pushing
the polarized connections together. (Fig. 18)
- White wire to White wire
- Black wire to Blue wire
Step 3. While holding the light fixture/switch
housing assembly under your ceiling fan, push
the square wire connectors together. One
from the fan and one from the switch housing.
(Fig. 19)
NOTE: These connectors are color coded and
will ONLY engage when the colored strips are
matched (aligned).
Step 4. Carefully push all the wires into the
switch housing on the light fixture/switch
housing assembly.
Attach the light fixture/switch housing
assembly to the mounting plate with the three
screws provided. Make sure each screw is
tight. (Fig. 19)
Monarch II Select
TM
Nut
Lock washer
Switch housing
Light fixture
Fig. 18
Mounting plate
Wire connector
light fixture/
switch housing
assembly
Fig. 19
10
Wire connectors
Plug
Screws