Important; End Panel Assembly Instructions - Hog Slat Grower SELECT HSES Manual De Instalación

Evaporative Cooling System
The supplied tube of PVC Cement (Weld·On® 719™) is a special Extra Heavy Bodied Slow Setting PVC
Plastic Cement and is the only adhesive that should be used to assemble cooling system trough
components together. It is a solvent based adhesive designed especially for gluing PVC components
together. The substitution of other adhesives and/or silicon, acrylic, etc. (painter's type) caulks will
result in leakage over time. They are sealants and not adhesives. The supplied cement should be
sufficient to glue applicable components but if additional cement is required; it can be obtained at any
1. Using methods in section shown above, insert cement and place final Splice on the end of the trough as
shown below in Figure 15.
2. Cut 2"X4" Cap to appropriate length according to Table F above.
3. Using screws (80509), toenail 2"x4" Cap into the rough opening ensuring it mounts flush to Trough End
with Nipple and in the middle of the last Trough Splice as shown below in Figure 15.
4. Again using supplied screws (80509),fasten End Panels to 2"X4" Cap as shown below. Fasteners should
be inserted through the holes in the side of the End Panel.
Hog Slat Inc. Newton Grove, NC USA November 2018

Important

Hog Slat retail outlet under part number
HSES-34.

End Panel Assembly Instructions

Figure 15
15