Programming A Supply Step - Alliance Laundry Systems UW35P2 Manual De Operación

Programming
Step Programming
4. Press the Heat key. The display will
read either "080F" or "025C," depending
on whether Fahrenheit or Centigrade
is prompted.
Enter the desired fill temperature. Three
digits must be entered. If the desired
temperature is less than 100 degrees, the
first digit must be 0.
The valid temperature range is 80–200
degrees Fahrenheit and 25–93 degrees
Centigrade. The computer will not accept
temperatures out of this range. (The fill
Keys Pressed
Hot + Low + Enter
Hot + Med + Enter
Hot + High + Enter
Warm + Warm + Low + Enter
Warm + Hot + Low + Enter
Warm + Cold + Low + Enter
Cold + Low + Enter
Cold + Med* + Enter
Cold + High + Enter
In addition to the standard fill temperatures, computer-controlled fill or overflow to a specific temperature is available.

Programming a Supply Step

The WE-6 microcomputer is capable of
controlling up to 5 separate supplies and up
to 31 various combinations of the 5 supplies.
(See the Supply Display Codes Table in this
subsection for a listing of the energized
supply compartments represented by each
display code.)
40
(Continued)
Fill Temperature Programming
Display
temperatures possible are governed by the
temperature of the available hot water.)
5. Press the Enter key. The display will read
"M---S." Now assign the maximum time
to be allowed for reaching the fill level in
minutes and seconds.
6. Press the Enter key, and go to the next
step in the cycle.
The computer will attempt to maintain the
temperature within a margin of plus or
minus 5 degrees of the target fill
temperature during such a step.
"HL" 1 Hot Fill and 1 Hot Spray
"HM" 1 Hot Fill and 1 Hot Spray
"HH" 1 Hot Fill and 1 Hot Spray
"WL" Both Hot and Both Cold
"WL" Both Hot and 1 Cold Fill
"WL" 1 Hot Fill and Both Cold
"CL" 1 Cold Fill and 1 Cold Spray
"CM" 1 Cold Fill and 1 Cold Spray
"CH" 1 Cold Fill and 1 Cold Spray
1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press the Supply key. The display will
read "S." Now press the number key–1, 2,
3, 4, or 5–that corresponds to the desired
supply valve.
Valves Operating
F232090