Transferring All Cycles From Simulator To Computer; Transferring One Cycle From Simulator To Computer - Alliance Laundry Systems UW35P2 Manual De Operación

9. Press the ENTER key. The simulator
display will flash "RECV" and "CYC"
alternately. The computer display will
flash "SEND" and "CYC" alternately.
When the two displays stop flashing, the
transfer is complete.
Transferring All Cycles from Simulator
to Computer
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer all
cycles contained in the memory of the
simulator to the computer. (Transferring 39
cycles takes about 6 seconds.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic
cables match the colors of the ports on the
simulator and on the washer-extractor's
control module (gray to gray, blue to blue).
2. Place both the simulator and the computer
in the PROGRAM mode. The display on
both will read "CYC00."
3. Press the 0 key. The display will read
"WRITE?"
4. Press the ENTER key. The display will
read "ALL."
5. Press the ENTER key again. The
simulator display will flash "SEND" and
"ALL" alternately. The computer display
will flash "RECV" and "ALL" alternately.
When the two displays stop flashing, the
transfer is complete.
F232090
Programming
Transferring One Cycle from Simulator
to Computer
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer one
cycle contained in the memory of the simulator
to the computer. (Transferring 1 cycle takes
less than 1 second.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic
cables match the colors of the ports on the
simulator and on the washer-extractor's
control module (gray to gray, blue to blue).
2. Place both the simulator and the computer
in the PROGRAM mode. The display on
both will read "CYC00."
3. Press the 0 key. The display will read
"WRITE?"
4. Press the ENTER key. The display will
read "ALL."
5. Press the 0 key. The display will read
"CYC00."
6. Press the ENTER key. The display will
read "RCYC00."
Now press the 2-digit code for the desired
cycle number from the simulator.
7. Press the ENTER key. The display will
read "WCYCcc."
Now press the 2-digit code for the desired
cycle number under which the cycle
should be saved in the computer.
8. Press the ENTER key. The simulator
display will flash "SEND" and "CYC"
alternately. The computer display will
flash "RECV" and "CYC" alternately.
When the two displays stop flashing, the
transfer is complete.
51