2- Cardan Shaft Length Reduction; 3- Coupling The Cardan Shaft - Nogueira SOFT DUO 1300 Manual De Instrucciones

4. Preparation

4.4.2- Cardan shaft length reduction

Mark the location where the
1.
indicated below. Uncouple the cardan shaft from the machine and the
tractor and make the cuts.
TRACTOR
25 mm
Recommendations:
ƒ The cut pieces of the bar, the tube and the
plastic protection of the cardan should have
the same length.
ƒ Using a lime, remove all the filings from the
tubes. Then, lubricate with a thin layer of grease.
ƒ Special attention should be given to the tube
and bar mounting on the square profile cardans.
The Terminals should be aligned as shown in the
figures below. Misaligned terminals generate
vibrations, wear and cardan breaks.
right -
aligned
wrong -
misaligned

4.4.3- Coupling the cardan shaft

ƒ Before coupling, lubricate the two cardan shaft terminals.
ƒ Couple the male side on the machine and the female side on the tractor.
32
cuts will be made, leaving the gap
cut
cut
Instructions Manual
25 mm
MACHINE