Cleaning Tips
• Allow the oven to cool to room temperature before
using the SpeedClean™ cycle.
• A plastic spatula can be used as a scraper to
scrape off any chunks or debris before and during
oven cleaning.
• Using the rough side of a non-scratch scouring pad
may help to take off burnt-on stains better than a
soft sponge or towel.
• Certain non-scratch scrubbing sponges, such as
those made of melamine foam, available at your
local stores, can also help improve cleaning.
• The oven should be level to ensure that the bottom
surface of the oven cavity is entirely covered by
water at the beginning of the SpeedClean™ cycle.
• For best results, use distilled or filtered water. Tap
water may leave mineral deposits on the oven
bottom.
• Soil baked on through several cooking cycles will
be more difficult to remove with the SpeedClean™
cycle.
• Do not open the oven door during the
SpeedClean™ cycle. Water will not get hot enough
if the door is opened during the cycle.
• For hard to reach areas such as the back surface
of the oven, it is better to use the Self Clean cycle.
SpeedClean™ Instruction Guide
1
Remove oven racks and accessories from the
oven.
2
Scrape off and remove any burnt-on debris with
a plastic scraper.
Suggested plastic scrapers:
• Hard plastic spatula
• Plastic pan scraper
• Plastic paint scraper
• Old credit card
3
If cleaning the oven, fill the steam feeder tank to
the maximum fill line with water.
4
Turn the Oven Mode knob to select the Clean
mode. Then select SpeedClean in the display.
5
Touch Start. The remaining time appears in the
display.
CAUTION
• Some surfaces may be hot after the
SpeedClean™ cycle. Wear rubber gloves while
cleaning to prevent burns.
• During the SpeedClean™ cycle, the oven
bottom becomes hot enough to cause burns.
Wait until the cycle is over before wiping the
inside surface of the oven. Failure to do so may
result in burns.
• Avoid leaning or resting on the oven door glass
while cleaning the oven cavity.
6
A tone will sound at the end of the 10-minute
cycle. turn the Oven Mode knob to the OFF
position to clear the display and end the tone.
7
After the cleaning cycle and during hand-
cleaning, enough water should remain on the
oven bottom to completely submerge all soils.
Add water if necessary. Place a towel on the
floor in front of the oven to capture any water
that may spill out during hand-cleaning.
MAINTENANCE
41