Gaggia Milano NEW CLASSIC Instrucciones Para El Uso página 23

ENGLISH
water"), and switch off the machine by pressing the
on/off button (Fig.1-2).
5. Let the descaling solution take eff ect for approxi-
mately 20 minutes with the machine turned off .
6. Turn on the machine by pressing the on/off button
(Fig.1-2).
Dispense 2 cups of water (about 150 ml each) from the
steam wand, switch off the machine by pressing the
on/off button (Fig.1-2) and leave it off for 3 minutes.
7. Repeat the water dispensing described in step 6, until
the water tank is completely empty.
8. Rinse the water tank and fi ll it with fresh drinking
water.
9. Place a container under the steam wand. Open the
steam/hot water knob (Fig.1-7) slowly by turning it
counter-clockwise.
Press the brew button (Fig.1-1) and the steam button
(Fig.1-3).
10. Dispense the whole water tank content through the
steam wand. To stop dispensing, press the brew but-
ton (Fig.1-1) and the steam button (Fig.1-3) again and
close the knob by turning it clockwise.
11. Fill the water tank with fresh drinking water.
12. Place a suitable container under the fi lter holder.
13. Press the brew button (Fig.1-1) and dispense all the
water in the tank. Once the water tank is empty, stop
dispensing by pressing the brew button (Fig.1-1) and
the steam button (Fig.1-3) again. At the end, empty
the container.
14. Remove the fi lter holder from the unit by turning
it from right to left and rinse it with fresh drinking
water.
15. Repeat the operations from step 8 once again, for a
total of 8 tanks. The machine is now ready to be used.
16. The descaling cycle is now complete.
17. Refi ll the water tank with fresh water. If necessary,
load the circuit as described in the chapter "Loading
the Circuit".
• 18 •