Luminance Brands Kathy Ireland Home VOLTA CF590RBQ00 Manual De Instrucciones página 8

3. Ceiling Fan Assembly
3.10
Place the Ceiling Cover over the Downrod (Figure 10).
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 10).
3.11
Route the three 80" Motor Wires through the Hanger
Ball (Figure 11).
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 11).
Pull the Hanger Ball up tight against the Pin and
securely tighten the Phillips head Set Screw in the
Hanger Ball (Figure 11).
Loose Set Screw could create Fan wobble.
3.12
The Fan comes with Black, Blue, and White Wires that
are 80-inches long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball/4.5" Downrod Assembly (Figure 12).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
Please call Customer Service at 1-800-777-4440
if you have any questions about installation and
operation of this Ceiling Fan.
(Continued)
Figure 10
4.5" DOWNROD
PHILLIPS HEAD
PHILLIPS HEAD
SET SCREW
SETSCREW
Figure 11
1/2-INCH
1/2-INCH
6 TO 9 6 TO 9
INCHES INCHES
Figure 12
8
DOWNROD
CEILING
COVER
PIN
HANGER BALL
BLUE WIRE
BLUE WIRE
BLACK WIRE
BLACK WIRE
WHITE WIRE
WHITE WIRE
HANGER BALL
HANGER BALL
ETL Model No.: CF590