Terminals Of Projector - Christie DHD800 Guía De Referencia Rápida

Terminals of Projector

The projector has two replaceable Interface board slots. The projector's functions can be extended by installing
the optional interface boards into the terminal slots. For the Optional Interface Boards, contact sales dealer
where you purchased the projector.
Replacement of Terminal
✔Note:
• In the event of replacement of interface board,
turn off the projector, press the Main On/Off
Switch to Off and unplug the AC power cord
from the AC outlet.
1 Remove 2 Screws from an interface board.
2 Pull out the interface board.
3 Replace the interface board. Insert a new interface
board along Guide to fi t Plug into Socket.
4 Tighten screws to secure the interface board.
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board, contact
your sales dealer. When contacting the sales dealer, tell
the Option Control Number (Op.cont.No.) in the menu
that is located on the bottom of the information menu.
INPUT/OUTPUT
TERMINALS
2 TERMINAL SLOTS (Factory set)
- 13 -
Plug
Figure shows Dual SDI
020-000247-02 Rev. 1 (01-2012)
Screws
Guide
Socket
Board
DHD800 Setup Guide