ACCESSORIES
HOOK SUSPENSIONS
Swivel and rigid type hook suspensions (see Figure 1) are
available for all Lodestar Electric Hoists. However, rigid type hook
suspensions are normally recommended for most application. The
hook suspensions are intended for suspending the hoist from a
trolley which has a single load bar (such as CM's
633 Trolleys) or for suspending the hoist from a fixed structure.
Figure 1. Hook Suspensions
LUG SUSPENSION
Lug suspensions (see Figure 2) are available for all Lodestar Electric
Hoists. These are rigid type suspensions wherein the lug shown
replaces the hook (Figure 1) in the suspension adapter. The Lug
suspensions are required for suspending the hoist from the Series
635 Low Headroom and Motor Driven Trolleys described next.
Figure 2. Lug Suspensions
Series 632 and
®
Figure 3. Series 635 Low Headroom Trolley
SERIES 635 LOW HEADROOM TROLLEY
These are manual push type trolleys (see Figure 3) designed for
use with the Lodestar Electric Chain Hoists. A rigid lug suspension
(see Figure 2) is required to suspend the hoist from the trolley. The
trolley is adjustable for operation on a range of American Standard
"S" beams as indicated in Table 1, and it will also operate on flat
flanged beams.
Figure 4. Series 635 Motor Driven Trolley
SERIES 635 MOTOR DRIVEN TROLLEY
The motor driven trolleys (see Figure 4) are self-contained and
supplied complete with independent controls and wiring, including
a four directional control station. A rigid lug suspension (see Figure
2) is required to suspend the hoist from the Motor Driven Trolley.
The hoist and trolley are joined electrically by connecting the hoist
control and power cords (supplied) into the hoist or trolley. The
trolley is adjustable for operation on a range of American Standard
"S" beams as indicated in Table 1, and it will also operate on
flat flanged beams.
6
(ENGLISH)
P/N: 83874 (REV. 627-T) September 2016