Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Clean the hood shield mounting locations with an
3
Position hood shield onto hood and align.
5
Install (1) self tapping screw and (1) washer to se-
cure. Tighten until snug. Repeat for opposite side.
7
DO NOT OVER TIGHTEN
Close hood and install bump ons at pre-cleaned loca-
tions on the hood surface where the hood shield may
9
NOTE: Actual application may vary slightly from illustrations.
alcohol pad.
contact.
Peel back approx. 2" (5 cm) of tape liner from each end of hood
4
With the hood shield in its final position, remove remaining tape
liner. Press firmly on all flanges to ensure adhesion.
6
Reattach the front grill by reinstalling the previously
removed (8) nuts. Hood shield flange should be
10 mm
8
Page 2 of 3
shield.
between the hood and grill.