Installation Steps - AVS Stepshield Instrucciones De Instalación

Installation Steps

Measure the length and the width of your
carpet
Width
1
Cut the stepshield along the cutting
guide grooves to the proper length and
width with a pair of scissors.
underside view of
stepshield
tape
3
Rotate the part slightly so that the tape will not come
in contact with the vehicle while placing it in position.
carpet
slide
5
Press along the top and side of the stepshield to
ensure good adhesion of the tape.
7
NOTE: Actual application may vary slightly from drawings.
door sill.
Length
cutting guide
grooves
slide
Free ends
rotate part
slightly
Page 2 of 3
Clean the area where the stepshield will
mount with an alcohol pad.
carpet
2
Peel back 2" (5cm) of tape liner from
each end of stepshield.
Free ends
4
Remove the remaining tape liner by pulling on free
ends.
carpet
6
Repeat Steps 1-7 for opposite side front, and if ap-
plicable left and right rears.
rubber door
seal
Free ends