Descargar Imprimir esta página

Installation Steps; Care And Cleaning - AVS Ventvisor Instrucciones De Instalación

Ocultar thumbs Ver también para Ventvisor:

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Steps

Align visor to the previously cleaned surface. To facilitate positioning, raise window up fully and open door slightly. The visor should not
lateral flange
3
Gently press the exposed areas of tape against the surface and
verify position. NOTE: Open door to ensure the visor does not
obstruct door.
4
Apply pressure along all flanges to ensure proper adhesion of tape.
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
obstruct opening and closing of door.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
rear flange
visor
With the visor in its final position, remove the remaining tape liner
5
4 Piece Set
7
Repeat Steps 1-7 for opposite side.
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
tape liner
by pulling on free ends.
The rear visor attaches with the same
preparation methods as the front visor.
trim

Publicidad

loading