Installation Steps; Care And Cleaning - AVS Bugflector Instrucciones De Instalación

Installation Steps

Locate (2) fasteners installed in the middle of the rubber trim on
the front edge of the underside of the hood.
3
Align hood shield with holes in hood. Hood shield slides UNDER the
rubber trim piece.
Hood shield UNDER rubber
5
Install (4) remaining fasteners.
DO NOT OVERTIGHTEN.
98059
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
trim
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Remove (2) middle fasteners from the rubber trim piece on the
4
Insert (2) fasteners through holes in rubber trim, then
through hood shield, and into hood. Tighten fasteners.
98042
6
Close hood. Install (4) bump ons on pre-cleaned areas
8
Lund International
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
front edge underside of hood.
fastener
rubber trim
DO NOT OVERTIGHTEN.
hood
hood shield
rubber trim
fastener
.
of hood surface
front edge of
hood