Installation Steps; Care And Cleaning - AVS Bugflector Instrucciones De Instalación

Installation Steps

Remove the corresponding fasteners from the outboard rubber trim pieces. This is necesary in order for the hood shield flange to slide
3
Align hood shield with holes in hood. Hood shield slides UNDER the
rubber trim pieces.
Hood shield UNDER rubber
4
Install (2) short fasteners by firmly pressing in with
DO NOT OVERTIGHTEN.
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
under the rubber trim piece.
trim
screwdriver.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30046
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Insert (2) long fasteners through holes in rubber trim,
then through hood shield, and into hood. Tighten
5
Close hood. Install (4) bump ons on pre-cleaned areas of
hood surface. Adjust bumper stops as needed to ensure
hood shield clears grille and headlights.
7
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
front edge of
hood
fastener
rubber trim
fasteners.
DO NOT OVERTIGHTEN.
hood
hood shield
rubber trim
fastener