Status Of Sample Tube Positions - Miltenyi Biotec gentleMACS Manual Del Usuario

4.4.1

Status of sample tube positions

All possible statuses of tube positions are shown in
Figure 4.7: Overview of tube position statuses displayed in the Main menu.
Tube position
1
4
2
3
4
5
6
7
8
Table 4.4: Overview of tube position statuses.
58
4.4.1 and described in Table 4.4 .
Status
Free
Selected
Ready and Heater installed
Ready
Running
Done
Aborted
Stand by
Description
No tube is inserted. The position is free to use.
Tube is inserted. After inserting a tube, the position is
automatically assigned the status "Selected". Programs
can only be designated to positions with the status
"Selected".
The tube position is ready. A tube and a heater were
inserted and a program was subsequently assigned by
confirming the selection with "OK". The program may
be commenced by pressing "Start". The program name
and duration are displayed. In this example, program
"37°C_m_tumor_01" will be completed within 5
minutes.
The tube position is ready. A tube was inserted and a
program was subsequently assigned by confirming the
selection with "OK". The program may be commenced
by pressing "Start". The program name and duration are
displayed. In this example, program" m_neoheart_01_
01" will be completed within 1 minute.
The program "m_ neoheart_01_01" is running. The
progress bar and timer display the time remaining to
complete the program, in this example, 15 seconds.
The program "m_ neoheart_01_01" is finished. The
timer displays the elapsed time since completion of the
program, in this example, 3 seconds.
The program was stopped. It is possible to abort any
program by pressing the required tube position on the
touchscreen. The timer displays the remaining time to
complete the program since abortion, in this example,
58 seconds.
The tube position was deselected. Inserted tubes are
automatically assigned the status "Selected".
Deselection of an inserted tube is achieved by pressing
the required tube position on the touchscreen. The
status of the tube position will change to "Stand by".
Note that programs cannot be assigned to tube
positions in the Stand by mode.