Derby cycle Focus Manual Del Usuario página 149

English–4
Adjusting the Assistance Mode
The level of assistance of the eBike drive when
pedaling can be adjusted via the drive HMI.
Note: For individual versions, it is possible that
the the assistance mode is pre-set and cannot
be changed. It is also possible that less modes
are available for selection than listed here.
A maximum of four assistance modes are avail-
able:
"ECO": Effective assistance at max-
imum efficiency for maximum cruis-
ing range
"TOUR": Uniform assistance, for
touring with long cruising range
"SPORT": Powerful assistance for
sportive riding off road as well as
for urban traffic
"SPEED": Maximum assistance,
supporting highest cadence for
sportive riding
To change the assistance mode, press the
"mode" button 4 until the desired mode is dis-
played in indicator f.
While using the start-assistance function, indi-
cation f goes out; the set assistance mode is
stored.
Adjusting the Assistance Level
In the set assistance mode, the assistance level
can be adjusted anytime, even during riding.
Note: For individual versions, it is possible that
the assistance level is pre-set and cannot be
changed.
A maximum of three assistance levels as well as
the assistance shut-off are possible.
Assistance
degree* at:
Assistance mode
"ECO"
"TOUR"
"SPORT"
"SPEED"
* The assistance degree can vary for individual versions.
0 276 001 X45 | (28.9.11)
Assistance level
"1" "2" "3"
30 % 60 % 100 %
45 % 80 % 120 %
70 % 140 % 180 %
90 % 160 % 250 %
To increase the assistance level, press the
button 6 until the desired level is displayed in in-
dicator c.
To decrease the assistance level, press the
button 7 until the desired level is displayed in in-
dicator c.
In assistance level "0", the drive is switched off.
The eBike can be operated as a normal bicycle
through pedaling.
While using the start-assistance function, indica-
tion c goes out; the set assistance level is stored.
Switching Start-assistance On/Off
Start-assistance can be used for additional sup-
port on the first meters when starting is difficult
(e.g., at a traffic light or when starting uphill). It
can also be used as a pushing aid when in the
lowest gear.
The start-assistance function may only be
used when starting or pushing the eBike.
Danger of injury when the wheels of the
eBike do not have ground contact while using
the start-assistance function.
To activate the start-assistance function, press
the button 6 longer than 1 second and con-
tinue to hold. The eBike drive is activated, indi-
cator d flashes and indicators c, e and f go out.
Start-assistance is switched off as soon as any
of the following points occur:
– You release button
– You press another button on the drive HMI,
– You pedal in forward or quickly in backward
direction,
– The wheels of the eBike are blocked (e.g.,
through braking or running against an ob-
struction),
– After achieving a speed of 16 km/h.
Switching the Lighting On/Off
Depending on country-specific regulations, two
lighting versions are possible:
– The front light, rear light and display lighting
can be switched on and off at the same time
via the drive HMI.
– Only the display lighting can be switched on
and off; the front and rear light of the eBike
are independent of the drive HMI.
6,
Bosch eBike Systems