Possible Problems And Solutions - GERATHERM oxy control Instrucciones De Uso

POSSIBLE PROBLEMS AND SOLUTIONS

Problem Possible Reason
SpO or PR 1. Finger is not
2
cannot be shown inserted correctly.
normally. 2. Patient's oxyhaemoglo-
bin level is too low
to be measured
SpO or PR is 1. Finger might not be
2
shown inserted far enough.
unstably 2. Finger is trembling or
the patient's body is
moving.
The oximeter 1. Battery power may be
Cannot be inadequate or not be
switched there at all.
On. 2. Batteries may have
been inserted incor-
rectly.
3. The oximeter might be
damaged.
„Finger out" 1. There is no finger on
Displayed on the pulse oximeter or
screen finger is not positioned
properly.
Indication lamps 1. The product is automa-
suddenly tically switched off if no
go off signal is detected for
longer than 8 seconds.
2. Low power/ Batteries
empty.
"Error3" or 1. Low power/ Batteries
"Error4" empty
Displayed on 2. Receiving sensor
screen shielded or
sensor damaged.
"Error7" 1. Low power/ Batteries
displayed empty
on screen 2. Infrared sensor
damaged.
Solution
1. Try inserting the finger
again.
2. Try several more times
if you are sure that there
is no problem with the
device. Please go to a
hospital in good
time to obtain a precise
diagnosis.
1. Try inserting the finger
again.
2. Try not to move.
1. Please replace batteries.
2. Please reinsert the
batteries.
3. Have the device tested by
the manufacturer
1. Place your finger in the
oximeter.
1. Normal
2. Replace the batteries.
1. Insert new batteries.
2. Have the device tested by
the manufacturer.
1. Change the batteries.
2. Have the device tested by
the manufacturer.
21
EN