Roland JX-305 Manual Del Usuario página 238

Ocultar thumbs Ver también para JX-305:
Tabla de contenido

Publicidad

Channel Aftertouch
status
2nd byte
DnH
vvH
* Not received when the Rx Switch parameter is OFF.
* The effect will apply according to the Aftertouch Control setting.
Pitch Bend Change
status
2nd byte
3rd byte
EnH
llH
mmH
mm,ll=Pitch Bend value:
00 00H–40 00H–7F 7FH (-8192–0–+8191)
* Not received when the Rx Switch parameter is OFF.
* The effect will apply according to the Pitch Bend Control setting.
Channel Mode messages
All Sound Off (Controller number 120)
status
2nd byte
3rd byte
BnH
78H
00H
* When this message is received, all notes currently sounding on the corresponding
channel will be turned off.
* Not received when the Rx Switch parameter is OFF.
Reset All Controllers (Controller number 121)
status
2nd byte
3rd byte
BnH
79H
00H
* Not received when the Rx Switch parameter is OFF.
* When this message is received, the following controllers will be set to their reset
values.
Controller
Reset value
Pitch Bend Change
±0 (center)
Polyphonic Key Pressure
0 (off)
Channel Pressure
0 (off)
Modulation
0 (off)
Expression
127 (maximum)
Hold 1
0 (off)
Sostenuto
0 (off)
Soft
0 (off)
Hold 2
0 (off)
RPN
Unset. Previously set data will not change.
All Note Off (Controller number 123)
status
2nd byte
3rd byte
BnH
7BH
00H
* When All Note Off is received, all currently sounding notes of the corresponding
channel will be turned off. However if Hold 1 or Sostenuto are on, the sound will be
held until these are turned off.
* Not received when the Rx Switch parameter is OFF.
Omni Off (Controller number 124)
status
2nd byte
3rd byte
BnH
7CH
00H
* The same processing as when All Note Off is received will be done.
* Not received when the Rx Switch parameter is OFF.
Omni On (Controller number 125)
status
2nd byte
3rd byte
BnH
7DH
00H
* The same processing as when All Note Off is received will be done. The instrument
will not be set to OMNI ON.
* Not received when the Rx Switch parameter is OFF.
238
Mono (Controller number 126)
status
2nd byte
3rd byte
BnH
7EH
mmH
mm=Mono number:
00H–10H (0–16)
* The same processing as when All Note Off is received will be done, and the Solo
Switch parameter will be set to ON.
* Not received when the Rx Switch parameter is OFF.
Poly (Controller number 127)
status
2nd byte
3rd byte
BnH
7FH
00H
* The same processing as when All Note Off is received will be done, and the Solo
Switch parameter will be set to OFF.
* Not received when the Rx Switch parameter is OFF.
System Realtime messages
Timing Clock
status
F8H
* This is received when Sync Mode is SLAVE. Settings can be made to synchronize or
the LFO rate or the effect rate.
Active Sensing
status
FEH
* When an Active Sensing message is received, the unit will begin monitoring the
interval at which MIDI messages are received. During monitoring, if more than 420 ms
passes without a message being received, the same processing will be done as when
All Sound Off, All Note Off, and Reset All Controllers messages are received. Then
monitoring will be halted.
System Exclusive messages
status
data byte
status
F0H
iiH, ddH, ......, eeH
F7H
F0H:
System Exclusive message status
ii = ID number:
This is the ID number (manufacturer ID) that specifies the
manufacturer whose exclusive message this is. Roland's
manufacturer ID is 41H.ID numbers 7EH and 7FH are defined in an
expansion of the MIDI standard as Universal Non-realtime messages
(7EH) and Universal Realtime Messages (7FH).
dd,..., ee = data:
00H–7FH (0–127)
F7H:
EOX (End Of Exclusive) This is the last status of system exclusive
message.
Universal Non-realtime System Exclusive Messages
Inquiry Request Message
Status
Data byte
Status
F0H
7EH, dev, 06H, 01H
F7H
Byte
Explanation
F0H
Exclusive status
7EH
ID number (universal non-realtime message)
dev
Device ID (dev:10H(17)-1FH(32))
06H
Sub ID#1 (General Information)
01H
Sub ID#2 (Inquiry Request)
F7H
EOX (End Of Exclusive)
* The "dev" is own device number or 7FH (Broadcast)
* When Inquiry Request is received, Inquiry Reply message will be transmitted.

Publicidad

Tabla de contenido
loading

Tabla de contenido