Operation; First Use - SATA jet 1000 A RP/HVLP Instrucciones De Servicio

Operating Instructions SATA Automatic Gun
Notice!
■ Connect the circulation pipe with seal to the material connection for material
circulation [5-2].
Notice!
To use the automatic gun again without material circulation, screw the
dummy plug in as far as it will go. Secure with Loctite 242. Check for
any damage and soiling and replace corresponding components as
required.
9.

Operation

Attention!
Loose screws can cause damage to parts or result in malfunctions.
→ Tighten all screws by hand and check that they are screwed tight.

9.1. First use

The automatic gun is supplied fully assembled and ready for operation.
After unpacking, check:
• Automatic gun damaged.
• Scope of supply complete (see chapter 5).
EN
129