Descargar Imprimir esta página

Mopar 82212148 Manual Del Usuario página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

13
35. Align the cluster bezel over the slots and firmly press
into place.
36. Connect the negative battery cable.
NOTE: REQ RADIO, After installation of the radio, re­
move the radio from "Transportation Mode" by pulling
the IOD fuse or using the scan tool and perform a bat­
tery reset.
PROGRAMMING THE WIN
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: On vehicles equipped with the Sentry Key Immobilizer System (SKIS), when the Wireless Ignition Node
(WIN) is replaced with a new unit, a diagnostic scan tool MUST be used to initialize the new WIN and to program
at least two Sentry Key FOBIK transponders before the vehicle can be operated.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available before running the routine
CAUTION: If the PCM and WIN are replaced at the same time, the PCM MUST be programmed before the WIN.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "WIN REPLACED"
• Select the "Start Misc Function" button
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified select "NEXT"
• Select "NEXT"
• Note On­Screen instructions and select the "FINISH" button
• Cycle ignition key after the successful routine completion.
PROGRAMMING IGNITION KEYS TO THE WIN
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available before running the routine
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PROGAMMING IGNITION KEYS OR KEY FOBS"
• Select "NEXT"
Oct 19, 2009
K6860909

Publicidad

loading