Mopar 82212148 Manual Del Usuario página 3

5. Locate the hood switch harness take off (1) located
next to the battery (3) running under the IPM, taped
on the existing vehicle harness. If the hood switch
harness take off is not present on the existing vehicle
harness, use the supplied wiring harness in the kit.
6. If the hood switch take off harness (1) is present on the
vehicle existing harness, remove the tape and route
the take off harness (1) through the hole of the hood
ajar switch bracket (2).
NOTE: Self­adjustment of the hood ajar switch
is a one­time feature.
ineffective, removed or requires readjustment, it
must be replaced with a new unit.
7. Position the hood ajar switch (1) near the hole in the
mounting bracket (2) on the left inner fender side
shield.
8. Pull the wire harness connector (3) through the switch
mounting bracket (2) and connect it to the hood ajar
switch (1).
9. From the top of the mounting bracket, press the hood
ajar switch downward (1) into the mounting hole of the
bracket until the integral switch latch tabs lock it into
place.
IF VEHICLE IS NOT EQUIPPED WITH HOOD SWITCH
HARNESS TAKE OFF
10. Remove the vehicle ground bolt (1) located next to the
battery.
11. Install the hood switch ground harness ground termi­
nal and install the vehicle ground bolt (1) back into the
inner fender.
Oct 19, 2009
If the switch is damaged,
3
K6860909