Mopar 82212148 Manual Del Usuario página 2

2
WinFobik based vehicles, the sales code must be added to the database and the Restore Vehicle Configuration
(using a diagnostic scan tool) must be performed prior to installing the new WIN module. Failure to do so will
render the WIN module's remote start function inoperative.
The technician should wait 1/2 hour between adding XBM sales code in DealerConnect before installing the WIN
module & restoring vehicle configuration. In the interim, the technician can install all other components except
the WIN module.
NOTE: Prior to installation, obtain the four digit PIN from the dealership's parts department.
NOTE: REQ radios only must be put into "Transportation Mode" before removal. With Ignition in RUN or AC­
CESSORY, press SET and DISK simultaneously until the radio displays "TRANSPORTATION" on the display or
for 5 seconds.
RESTORE VEHICLE CONFIGURATION
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
1. VIN must be updated with the sales code of the added accessory in order to enable system functionality. Using the
DealerCONNECT website and the wiTECH diagnostic application, complete the vehicle configuration.
2. Log on to https://dealerconnect.chrysler.com.
3. In the "Vehicle Option" screen under the "Global Claims System" category in the "Service" tab, enter the vehicle
VIN, four digit pin number obtained from the dealership parts department and add sales code(s) noted below as a
"Dealer Installed Option".
XBM (REMOTE START)
4. Confirm that the new sales code has been successfully added to the VIN.
5. With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Highlight "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
• Note On­Screen instructions and select the "Close" button
PROCEDURE STEPS:
HOOD SWITCH AND HARNESS INSTALLATION
NOTE: It may be necessary to loosen or remove
the battery to install the hood switch, bracket and
harness.
1. Disconnect and isolate the negative battery cable.
2. Locate the hood switch mounting location, near the
battery on the driver side inner fender (1).
3. Position the hood ajar switch bracket (2) onto the
driver side inner fender (1).
4. Install the rivets (3) provided in the kit to secure the
hood ajar switch bracket to the driver side inner fender
(1).
Oct 19, 2009 K6860909