Temperature Setpoint Setting/Variation; Smart Functions - Quick-Access Functions - Sagi XE70 Instrucciones Originales - Manual De Uso E Instalación

TEMPERATURE SETPOINT SETTING/VARIATION

Press and release the key on/sby/enter: the current setpoint blinks on the
display for 5 seconds.
After 5 seconds, the displays shows the room temperature again
While the display is blinking, use the up and down keys to increase or
decrease the temperature setpoint
Press the key on/sby/enter again to confirm the new setpoint:
The new value acquisition is signalled by 3 consecutive, short beeps.
SMART FUNCTIONS – Quick-access functions
Hold the key menu pressed for over 3 seconds to gain access to the
quick-access function.
The display shows the first smart function option.
The function [Def / nDf] blinks at high frequency
Press the key on/sby/enter to confirm your selection and activate/de-
activate the function.
The forced manual defrost starts only if it is necessary.
Hyper Cold cannot be started during this phase.
You can leave the programming phase by waiting for 30 seconds without operating on the
card, or pressing
In both cases, there you will hear 3 consecutive, short beeps and the display will
temporarily show [ESC].
Hold the key menu pressed for over 3 seconds to gain access to the
quick-access function.
The display shows the first smart function option.
It blinks at high frequency.
Use the up and down keys to display the function [HCo / nHC].
Press the key on/sby/enter to confirm your selection and activate/de-
activate the function.
During this phase, defrost is not performed and you cannot start the Energy Saving
system.
FORCED MANUAL DEFROST
for 5 seconds.
HYPER COLD
20