Intelligent Defrost; Energy Saving; Loading The Product - Sagi XE70 Instrucciones Originales - Manual De Uso E Instalación

INTELLIGENT DEFROST: a totally automatic system allowing to start defrost cycles only
if it is necessary.
In pursuance of an energy saving policy and for best foodstuffs storing, defrost cycles are
automatically performed not at pre-set intervals but according to the evaporator state.
The control card is able to monitor operation through some functional parameters: defrost
starts only if it is really necessary, which basically depends on the type of use of the
appliance and on the type of foodstuffs stored.
ENERGY SAVING: a totally automatic system which allows energy saving through the use
of the appliance.
This system operates when the appliance is not being used, with door closed, and
constant inside temperature close to the setpoint value.
This function stops in the following cases:
- manual or automatic defrost activation
- manual activation of Hiper Cold function
- room temperature reading out of the set parameters
- operation with faulty room probe
- manual variation of the room setpoint
- different setting of evaporator fan operation
• Now and not before it is possible to put the food to conserve into
the refrigerator.
• Place the products into the cell uniformly to allow a good internal
air circulation across the cell.
• Avoid obstructing the ventilation areas inside the refrigerator.
• Only load the top shelf up to the stacking mark.
• Do not place products below the bottom shelf support.
• Cover or wrap food before introducing it into the refrigerator and
avoid introducing warm food or steaming liquids.
• Only leave the door open for the strict amount of time necessary to introduce or
remove food
WARNING: If ambient conditions do not allow the
evaporation of condense water through the
automatic system, insert container on the
external bottom part or convey water toward
sewerage.

INTELLIGENT DEFROST

ENERGY SAVING

LOADING THE PRODUCT

31