Troubleshooting - Concept VP4170 Manual Del Usuario

EN
CLEANING AND MAINTENANCE
Cleaning the rotary brush
Cleaning or replacement of the UV lamp
a) Pull the two UV lamp cover locks using your fingers.
b) Then open the cover.
84
a) Pull the two rotary brush cover
locks using your fingers.
b) Then open the cover.
• Remove the rotary brush and clean
it.
• Remove hair from the rotary brush.
a) Grab the UV lamp with your fingers and rotate
it 90° clockwise or counterclockwise.
b) Remove the UV lamp tube.
VP4170

TROUBLESHOOTING

Problem
The bed cleaning adaptor does
The wheel protection switch is off
not work the surface of the bed
Poor contact between the hand-
held vacuum cleaner and the bed
cleaning adaptor.
Rotary brush does not rotate
Rotary brush is blocked.
UV lamp is not working UV lamp is installed incorrectly
The UV lamp has reached the end of
its lifespan.
One of the two initiation devices is
not activated.
VP4170
Cause Remedy
Place the appliance on the bed and
turn it on. Check that there is no
sound coming out from the rotary
brush or UV lamp tube. UV radiation
is harmful to eyes; do not look
directly into the UV light.
Remove and reinsert the hand-
held vacuum cleaner from the bed
cleaning adaptor. Make sure they
are properly reassembled.
Clean the rotary brush as described
in the instruction manual.
Remove and reinsert the UV lamp.
For spare parts, contact technical
support.
Place the appliance directly on the
surface of the bed. Ensure that the
rear wheel and the rotary brush
touch the bed surface.
EN
85