Remote Control; Mounting The Wall Bracket; Initial Operation; New Registration Of Remote Control At The Instant Water Heater - clage DSX Touch Manual Del Usuario

DSX Touch

3. Remote control

EN
Figure A:
Installation with adhesive tape
Figure B:
Optional installation with dowels and screws
Technical data
Model
Operating voltage
Type of battery
Type of protection
Transmission range
Transmission power
Transmission and receiv­
ing frequency range
Radiation
Approvals
1) Do not use rechargeable batteries.

Mounting the wall bracket

• Before attaching the wall bracket to the wall, ensure that the remote control has
radio contact to the instantaneous water heater from its designated position and is
protected against splashing water.
• The wall bracket of the remote control can either be attached securely with the
included adhesive tape, after stripping off the protection film (as shown in the fig­
ure A), on a rigid board (e.g. tile) or with suitable dowels (Ø 4 mm) and screws (as
shown in the figure B).
• When mounting with adhesive tape, ensure that the mounting surface is dry and
free of grease and soap.
• When using the adhesive tape it is not possible to further adjust the position
because of the strong adherence of the glue. Therefore, pay attention to a horizon­
tal alignment when attaching it.
• The remote control is magnetically retained at the wall bracket.
• Keep the remote control and wall bracket away from credit cards or other cards
with magnetic strips. The built in magnets can damage the card's magnetic strip.

Initial operation

By the time the power settings have been carried out and the power supply to the
instantaneous water heater is enabled, insert the batteries into the remote control.

New registration of remote control at the instant water heater

1. Make sure that the power supply to the instantaneous water heater is switched on
(fuse).
2. Remove the batteries until the display expires. After inserting the batteries, the dis­
play indicates all symbols for about 4 seconds.
3. The remote control connects to the appliance automatically and the display switch­
es to the setpoint value display.
In the case of an unsuccessful registration the display indicates "
radio signal after 45 seconds. The remote control quits the registration process and
switches to standby mode. By pressing a key the registration process will be repeated.
Notes:
• With no remote control registered or without working radio connection, the instan­
taneous water heater heats to the prior selected set temperature.
• Only one remote control per appliance can be registered.
40
FX 3 Remote control
3 V
2x AAA Alkaline
1)
IP 20
10 metres incl. barrier
< 8 mW
2,4 – 2,4385 GHz
undirected
Europe EN 300 328 / CE
" and a flashing
bt