Squeegee; Disassembling/Assembling The Squeegee; Choosing The Type Of Squeegee Rubbers; Installing/Removing The Squeegee Rubbers - NSS CHAMP 2417 RB Manual De Uso

Proceed as follows to assemble/disassemble the squeegee (A) on the machine:
!
ATTENTION!
Before activating the ignition key (B), always check for any foreign bodies between the squeegee (A) and the
machine, as they may obstruct the squeegee lifting.

Disassembling/Assembling the squeegee

• Rotate the ignition key (B) to "I", then wait a few seconds until the machine "Ready" caption (D) appears on the
display (C).
• Wait for the squeegee (A) to lift and the light (E) to turn off .
• Rotate the ignition key (B) to "0" and remove it.
• Remove the squeegee (A) from its mount (H) after disconnecting the suction pipe (G) and loosening the two
knobs (F).
• Fit the squeegee (A) back in place by connecting the suction pipe (G), moving the squeegee (A) inline with the
fi xing slots located on mount (H) and fastening the knobs (F).
!
ATTENTION!
Using the machine with the squeegee not perfectly assembled may cause injury to people and damage to
equipment.
Always ensure that all components have been assembled before starting the machine. Carefully inspect the
machine before using it.

Choosing the type of squeegee rubbers

Choosing the most appropriate rubbers is essential for surface treatment.
You can clean more quickly with the proper abrasive disc; furthermore, the increase in productivity may result in
substantial cost savings.

Installing/removing the squeegee rubbers

See the procedure in the "Maintenance - Replacing the rear rubber - Replacing the front rubber" chapter for installing/
removing the squeegee rubbers.
D

SQUEEGEE

E
C
B
F
Slot
H
23
F
A
G