After Using The Machine; Machine Long Downtime - NSS CHAMP 2417 RB Manual De Uso

The following operations must be carried out after using the machine at the end of work.
• Remove and clean the brushes or abrasive discs, following the procedure described in the "Maintenance -
Cleaning the disc brushes" chapter.
• Empty the tanks, following the procedure described in the specifi c section.
• Remove and clean the squeegee, following the procedure described in the "Maintenance - Cleaning the squee-
gee" chapter.
• Recharge the batteries if necessary, following the procedure described in the "Maintenance - Charging the
batteries" chapter.
• Store the machine in a dry and clean place with the brushes or abrasive discs and squeegee raised.
In the event of a machine downtime longer than 30 days, the following steps should be carried out:
• Follow the instructions reported in the "After using the machine" section.
• Clean the detergent feeding system (upon request), as described in the "Emptying the 5-Litre detergent tank"
(DETERSAVER) section.
• Disconnect the battery connector as described below.
• Lift the lever (A) to unlock the battery compartment door (B) and use the handle to open it (C).
• Remove the battery holder case (D) by pulling the handle (E) until reaching the locking tabs (F) located on the
door (B).
• Disconnect the battery (H) connector (G).
• Put the battery holder case (D) back in its seat, close the door (B) again using the handle (C) until the lever (A)
is automatically locked.
• Store the machine in a dry and clean place with the brush(es) or pad holder and squeegee removed or raised.
C
B
E H
D

AFTER USING THE MACHINE

LONG MACHINE DOWNTIME
A
29
H
D
E
F
F
G