Starting And Stopping The Machine; Starting The Machine - NSS CHAMP 2417 RB Manual De Uso

Starting the machine

• Set the machine as described in the previous section.
• Sit on the machine seat (A).
• Rotate the ignition key (B) to "I", then wait a few seconds until the machine "READY" caption (D) appears on the
display (C).
!
ATTENTION!
Do not rotate the ignition key (B) without fi rst sitting on the seat (A), as the machine is equipped with a safety
system preventing it to work if the operator is not sitting on the seat (A).
It is strictly forbidden to tamper with the seat safety system or to simulate in any way the operator sitting on
the seat.
If the ignition key (B) is turned and the operator is not sitting on the seat, the "SIT DOWN" caption appears on the dis-
play (D) and no machine functions are available. When the display shows indications other than those described, an
intervention is required from the NSS Service Centre.
• Check the battery charging status by observing the percentage (E) and relative graphic (F).
Charge the batteries if necessary by following the procedure in the "Maintenance - Charging the batteries"
chapter.
!
ATTENTION!
The machine is not suitable for use on uneven fl oors.
• Go to the work area after starting the machine with your hands on the steering wheel and pressing the pedal
(G). The forward speed is adjustable from zero to its maximum set value, based on the pressure exerted on the
pedal (G).
• When required, the reverse gear can be engaged by releasing the pedal (G) and pressing the button (H) as soon
as the machine has stopped.
• If required, use the buttons (I) to adjust the fl ow of the detergent solution (or washing water).
• Buttons (J) can be used to adjust the percentage of the washing detergent.
• Press button (L) to activate the brush(es) and start washing the fl oor.
• Press button (M) to activate the vacuum and start drying the fl oor.
• Press button (N) to start both the washing and drying procedures.
• Press button (L) to start polishing the fl oor with the abrasive discs.
• Start cleaning/polishing by manually moving the steering wheel (P) and pressing the pedal (G) to move the
machine forwards.
A

STARTING AND STOPPING THE MACHINE

P
G
I
H
25
J
L M N