Checking The Machine Operating Hours; Cleaning The Squeegee - NSS CHAMP 2417 RB Manual De Uso

Checking the machine operating hours

• Sit on the machine seat.
• Rotate the ignition key (A) to "I", then wait a few seconds until the machine "READY" caption (C) appears on the
display (B).
• The area (D) displays the number of machine operating hours.
• Rotate the machine ignition key to "0" and remove it.

Cleaning the squeegee

NOTE!
In order to dry the fl oor properly, the squeegee must be clean and the rubbers in good condition.
!
WARNING!
It is advisable to use protective gloves when cleaning the squeegee since sharp debris may be attached to it.
• Disassemble the squeegee, if necessary (See procedure in the specifi c section).
• Wash and clean the squeegee (E), carefully removing dirt and debris from the recovery water inlet (F).
Check that the front rubber (G) and the rear rubber (H) are intact and have no cuts or tears, otherwise replace
them (see the procedure in the specifi c section).
• Reassemble the squeegee if it had been disassembled (See procedure in the specifi c section).
E
F
A
H
31
C B D
G