Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Checking the squeegee rubbers
•
Remove and clean the squeegee, following the procedure described in the specifi c section.
•
Check
that
tact
and
have
Also check that the front edge (C) of the rear rubber (B) is not worn out, otherwise detach the rubber and
reverse it, moving one of the other three edges (if still intact) to the front edge (C) position. Replace the rear
rubber if the other three edges are also worn out, as described below.
Replacing the rear squeegee rubber
•
Disengage the safety catch (D) and open the eccentric (E), then disengage it from the hook (I).
•
Remove the two knobs (F).
•
Remove the holding plates (G) and (H).
•
Replace (or reverse) the rear rubber (B) then reassemble the removed parts, operating in reverse order than
removal.
Replacing the front squeegee rubber
•
Unscrew the wing nuts (L) located on the inside of the squeegee.
•
Remove the holding plates (M).
•
Replace the front rubber (N), then reassemble the removed parts, operating in reverse order than removal.
Resetting the squeegee
•
Reassemble the squeegee, as described in the specifi c section.
•
Adjust the height of the squeegee if necessary, as described in the specifi c section.
N
C
B
the
front
rubber
no
cuts
and
tears,
B
M
L
A
(A)
and
the
rear
otherwise
replace
D
E
F
32
rubber
(B)
are
them
as
described
I
F
in-
below.
Publicidad
Capítulos
Tabla de contenido
