Batteries; Checking/Installing Batteries On A New Machine; Installing/Replacing The Batteries; Setting The Type Of Batteries Installed - NSS CHAMP 2417 RB Manual De Uso

Checking/installing the batteries on a new machine
!
Caution!
The machines are predisposed for LEAD-ACID batteries.
To charge the batteries, see "Charging the batteries " section , page 37.
!
ATTENTION!
This machine electrical components may become severely damaged if the batteries are not installed and con-
nected properly. The batteries must be installed only by qualifi ed personnel. The machine must also be set,
according to the batteries used: WET, GEL, AGM. Check the batteries before installing them to make sure they
are not damaged. Disconnect the battery connector and the battery charger plug.
Handle batteries carefully. Install the protective caps of the battery terminals.
The machine can be supplied in one of the following confi gurations:
• With batteries (WET or GEL or AGM) already installed on the machine and ready for use.
• Batteries not supplied
Depending on the type of supply received, operate as follows.
a) Batteries (WET or GEL or AGM) already installed on the machine and ready for use.
1. The machine is suitable for use.
b) Batteries not supplied
2. Purchase suitable batteries (See the "Technical features" section).
Contact qualifi ed dealers for battery selection and installation.

Installing/replacing the batteries

This operation must be performed by a specialised technician;
contact the Authorized Service Center for relevant instructions.

Setting the type of batteries installed

This operation must be performed by a specialised technician
(see, Changing the set parameters of the charging curve with
battery charger on board).
We recommend to CONTACT THE AUTHORIZED SERVICE
CENTER FOR RELEVANT INSTRUCTIONS.
Accessing the battery charger on board in case of settings
To access the battery charger 1 proceed as follows:
• Use knob 2 to open cover 3 and remove it from its lock-
ing pins 4 .
• Unscrew bolts 5 and lift protection 6.
• Tilt the electronic unit 7 as indicated by the arrow in pic-
ture.
2
3
4
4

BATTERIES

6
3
5
18
Label indicates the charger setting
as delivered. See chart page 19.
1
5
5
5