Stopping The Machine; Machine In Operation; Adjustments And Checks - NSS CHAMP 2417 RB Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Stopping the machine

Release the pedal (G).
Press button (L) or (M) or (N) "page 25". to deactivate and lift the relevant functions enabled.
Vacuum stops a few seconds after the relevant button is pressed in order to drain all water in the tube.
Turn the ignition key (2) "page 9" to "0" and remove it.
The machine does not need to be locked during stopping or parking as the electromagnetic brake on the
front wheel automatically brakes the machine when the accelerator is not pressed.
If required, empty the tanks following the procedure described in the specifi c section.
!
ATTENTION!
Do not leave the machine unattended without fi rst removing the ignition key.
Press button (Q) as indicated by the "ON" arrow to immediately stop the machine in an emergency. To disable
the emergency button (Q), pull it until it releases from its pressed position as indicated by the "OFF" arrow.
OFF
OFF

Adjustments and checks

Start the machine as described in the previous chapter.
If necessary, adjust the squeegee (T) (see the procedure in the "Maintenance - Adjusting the squeegee" chap-
ter).
If required, use the buttons (I - "page 25") to change the fl ow of the detergent solution (or washing water).
If required, use the buttons (J - "page 25") to change the percentage of the washing detergent.
If required, use the button (10 - "page 10") to change the maximum speed of the machine.
If required, press the "GREEN" button (8 - "page 10") to enable the minimum fl ow of water or detergent solution,
as well as the brush rotation speed.
Periodically check the battery charging status during work to prevent fl at battery conditions in areas far from
any charging points. To charge the batteries, see the procedure in the "Maintenance - Charging the batteries"
chapter.
If the recovery water tank fi lls during machine use, suction will automatically stop and can be restarted only by
emptying the recovery water tank (see the procedure in the specifi c section).
Use the relative level indicator (S) to periodically check the residual quantity of detergent solution (or washing
water).
If required, empty the tank at the end of work (see the procedure in the relevant Chapter).
ON
ON
S
Q

MACHINE IN OPERATION

T
26
G

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido