Disassembling/Assembling The Vacuum Motor - NSS CHAMP 2417 RB Manual De Uso

Disassembling/assembling the vacuum motor

Proceed as follows to disassemble the vacuum motor:
• If available, place the machine on a raised platform, otherwise place it on a level fl oor.
• Using the machine controls, lower the brush and the squeegee, then turn the ignition key to "0" and remove it.
• Open the battery holder case and disconnect the battery connector (see procedure in the "opening/closing the
battery holder case" section ).
• Operate on the left side of the machine to unfasten the screws (A).
• After disconnecting the electrical connector (C) of the vacuum motor, remove the mount unit with the vacuum
motor and fi lter (B).
• Working at the bench, remove the soundproof gasket (D).
• Cautiously remove the vacuum motor (E) by disengaging it from the suction fi lter (F).
Proceed as follows to assemble the motor:
• Reassemble it, following the disassembly operations in reverse order.
A A
B
39
C D
E
F