Lexmark X820e Manual Del Usuario página 21

Installing the printer
operator panel cover
Operator panel cover
Housing
lling the printer
ator panel cover
Power switch cover
Replacement
housing
Subassembly
Cable
Recess
Installing the operator panel cover and
the power switch cover is optional. It is
not necessary for the proper functioning
of the MFP.
1
Make sure the printer is
unplugged. Pull up on the
operator panel to unsnap it, and
then gently remove it.
2
Disconnect the cable from the
operator panel. Leave the cable
attached to the printer.
3
Remove the three screws from the
back of the operator panel and
separate the housing from the
subassembly. Save the screws.
4
Insert the subassembly into the
replacement housing and then
secure with three screws.
5
Connect the cable to the operator
panel.
6
Gently press the operator panel
into the recess on the front of the
printer until it snaps into place.
Complete the hardware setup
13