RUNNING-IN
The running-in of the engine is important to
ensure its correct functioning.
If possible, drive on hilly roads and/or
roads with many bends, so that the engine,
the suspensions and the brakes undergo a
more effective running-in.
During running-in, change speed. In this
way the components are first ≈loaded∆ and
then ≈relieved∆ and the engine parts can
thus cool down.
Even if it is important to stress the engine
components during running-in, take care
not to exceed.
CAUTION
Only after the first 1500 km of running-
in you can expect the best performance
levels from the vehicle.
Keep to the following indications:
Do not open the throttle completely if the
◆
speed is low, both during and after the
running-in.
During the first 100 km put on the brakes
◆
w i t h c a u t i o n , a v o i d i n g s h a r p a n d
prolonged brakings.
This ensures a correct bedding-in of the
pads on the brake disc.
During the first 800 km, never open
◆
throttles more than half their way.
WARNING
After the first 1000 km, carry out the
checking operations indicated in the
c o l u m n " A f t e r r u n n i n g - i n " o f t h e
R E G U L A R S E R V I C E I N T E R V A L S
C H A R T , s e e p a g . 5 6 ( R E G U L A R
SERVICE INTERVALS CHART), in order
to avoid hurting yourself or other
people and/or damaging the vehicle.
Between the first 800 and 1,500 km ride
◆
the vehicle more lively, change speed
and fully open throttles just for a few
seconds so as to allow parts better
coupling. Do not open throttles more
than 3/4 of their way.
After the first 1,500 km you can expect
◆
better performance from the engine.
However, do not exceed the max.
speeds indicated in the table and the
engine max. rpm.
Throttles max. opening
during running-in
Mileage km
Throttles opening
0...800
800...1,500
oltre 1,500
STOPPING
If possible, avoid stopping abruptly,
slowing down suddenly and braking at
the last moment.
Release the throttle grip (1) (Pos. A),
◆
gradually put on the brakes and at the
s a m e t i m e s h i f t d o w n i n o r d e r t o
d e c r e a s e t h e s p e e d , s e e p a g . 5 0
(DEPARTURE AND DRIVE).
1/2
Once the speed has decreased, before
3/4
stopping the vehicle:
4/4
Pull the clutch lever (2) in order to
◆
prevent the stopping of the engine.
When the vehicle has come to rest:
Position the shifting lever in neutral
◆
(green warning light " " on).
Release the clutch lever (2).
◆
In case of a brief stop, keep at least one
◆
brake on.
WARNING
use and maintenance MX 125
53