Changing The Headlight Bulbs - APRILIA MX 125 Manual De Instrucciones

CHANGING
THE HEADLIGHT BULBS
Carefully read pag. 78 (BULBS).
CAUTION
Before changing a bulb, check the
fuses, see pag. 76 (CHANGING THE
FUSES).
The headlight contains:
A parking light bulb (1).
◆
A low beam/high
◆
(halogenous) (2).
To change the bulbs, proceed as follows:
WARNING
The front part of the fairing
with the headlight, remains connected
to the electric wires; do not pull them.
Remove the two ties (3), used to secure
◆
9
front fairing to frame, from forks.
Handle the plastic components with
care and avoid scraping or damaging
them.
Withdraw the front part of the fairing (4),
◆
complete with the headlight, downwards
and disconnect it from the pin (5)
provided on the dashboard.
PARKING LIGHT BULB
beam bulb
To extract the bulb socket, do not pull
its electric wires.
Grasp the bulb socket (6), pull and
◆
(4), complete
disconnect it from its seat.
Withdraw the parking light bulb (1) and
◆
replace it with one of the same type.
6
1
2
8
7
WARNING
CAUTION
9
8
LOW / HIGH BEAM BULB (HALOG-
ENOUS)
CAUTION
To extract the bulb electric connector,
do not pull its electric wires.
Grasp the bulb electric connector (7),
◆
pull it and disconnect it from the bulb (8).
Remove housing (9) from reflector and
◆
from bulb terminals
Turn bulb holder (8) anticlockwise to
◆
remove it from reflector
Remove bulb (2) from its location
◆
For the installation:
NOTE
Insert the bulb in the bulb socket,
making the relevant positioning seats
coincide.
Position bulb holder (6) into reflector and
◆
turn it clockwise.
Correctly install housing (9) inside bulb
◆
terminals and reflector.
Connect bulb (7) connector.
◆
use and maintenance MX 125
2
79